Reinstall The Sliding Panel - Pella 81CM0100 Installation Instructions Manual

5
INSTALLING THE INTERIOR INSTALLATION SCREWS
A.
the top (head) and sides (jambs) of the unit frame.
B.
the door frame into the rough framing. Drive the screws until snug, DO NOT over-
tighten the screws. DO NOT bend or bow the unit frame.
EXTERIOR
STUCCO
ERIOR INTERIOR
C.
then insert a #10 x
3-1/2" corrosion resistant
screw into each hole.
6

REINSTALL THE SLIDING PANEL

TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL SAFELY.
A.
top of the panel toward the door frame and insert the top
of the door panel into the top track. Move the bottom of the
panel toward the door frame until it is vertical. Gently set the
panel down into the bottom track. Adjust the panel clip and
tighten the panel clip screw.
Note: Be careful not to pinch your fingers between the
two panels. DO NOT close the sliding panel until you have
installed the hardware. The door may lock when closed.
B.
package. If the panel is not square to the door frame, adjust the bottom rollers by
removing the adjusting hole cover and inserting an 8" long #2 Phillips screwdriver into
the hole. Turn clockwise to raise the panel and counter-clockwise to lower the panel.
C.
into the rough framing through the clearance holes in
drive #10 x 3-1/2" corrosion resistant wood screws through
FIXED JAMB
5A
From the exterior of the building, tilt the
Instructions for installing the screen are found in the screen door package.
Drill 1/8" diameter pilot
hole through the clearance
hole in the frame.
5B
#10 x 3-1/2"
corrosion resistant wood screw
13/16" Pilot
Sealant
goes here
Follow the instructions included in the hardware
VENT JAMB
5C
6A
6A
EXTERIOR
STUCCO
INTERIOR
R O R I E