Pella V983492 Installation Instructions Manual page 9

6
INTERIOR SEAL (CONTINUED)
B. On the interior, seal the door sill to the floor with a corner bead of sealant. Connect this
bead of sealant to the insulating foam at both door jambs.
C. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level,
square and the sides are not bowed. If adjustments are required, remove the foam
with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
7
SEALING THE DOOR TO THE EXTERIOR
WALL CLADDING
NAIL-fIN fRAME:
Note: When applying siding, brick veneer or other exterior finish materials, leave
adequate space between the door frame and the material for sealant. Refer to the
illustration that corresponds to your finish material. Not allowing adequate space or
not using backer rod may cause the sealant to break down prematurely and allow
water to infiltrate.
BRICK VENEER
Insulating
Foam
3/8"
1/2" Min.
REPLACEMENT fRAME:
Note: When applying siding, brick veneer or other exterior finish materials, leave
adequate space between the door frame and the material for sealant. Refer to the
illustration that corresponds to your finish material. Not allowing adequate space
or not using backer rod may cause the sealant to break down prematurely and allow
water to infiltrate.
Insulating
Foam
Backer rod
and
sealant
typical
Insulating
Foam
BRICK VENEER
3/8"
3/8" Min.
VINYL/STEEL
SIDING
Backer rod
sealant
typical
Insulating
Foam
3/8"
1/2" Min.
WOOD SIDING
WITH TRIM
Backer rod
and
sealant typical
Insulating
Foam
Page-9
WOOD SIDING
WITH TRIM
and
3/8"
1/2" Min.
Backer rod
and
sealant typical
3/8"
3/8" Min.
Backer rod
and
sealant
typical