Pella V983492 Installation Instructions Manual page 2

REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT.
Nailing Fin
Corner
Top
Flashing
Flashing
Tape
Tape
Corner
Side
Flashing
Flashing
Tape
Tape
Wood Blocking
Side Flashing Tape
Always read the Vinyl Window and Door Limited Warranty before purchasing
or installing Vinyl Windows and Doors manufactured by Pella Corporation. By
installing this product, you are acknowledging that this Limited Warranty is part of the terms of the
sale. Failure to comply with all Pella installation and maintenance instructions may void your Pella
product warranty. See Limited Warranty for complete details at http://warranty.pella.com.
YOU WILL NEED TO SUPPLY:
• Cedar/impervious shims/spacers (24 to 40)
• 2" galvanized roofing nails (Nail-fin only) (1/4 lb.)
• 1/4" x 2" masonry screws for concrete application
• Closed cell foam backer rod/sealant backer (20 to 30 ft.)
• Pella® SmartFlash™ foil backed butyl window and
door flashing tape or equivalent
• High quality exterior grade polyurethane or
silicone sealant (2 to 3 tubes per door)
• Great Stuff™ Window and Door Insulating Foam Sealant by the
• Dow Chemical Company or equivalent low pressure polyurethane
window and door foam - DO NOT use high pressure or latex foams.
• Pella aluminum sill support or 2 x 4 wood blocking
• Pella sill pan or equivalent
• Interior trim and/or jamb extensions (20 to 30 ft.)
Installation will require two or more
persons for safety reasons.
Head
Sill Flashing Tape #1
Sill
Page-2
Water
Resistive
Barrier
Sheathing
Framing
Sill Flashing Tape #2
Head
Wood Blocking
TOOLS REQUIRED:
• T ape measure
• L evel
• S quare
• H ammer
• S tapler
• S ealant gun
• S cissors or utility knife
• S crewdrivers (#2 Phillips)
• 3 "-5" Wide putty knife
• D rill
• # 2 Phillips bit
• S quare (Robertson)
drill bit
Concrete
block
Sill
Sill Flashing Tape #1
Sill Flashing Tape #2