Table of Contents
Advertisement
3. E xternal Microphone
Connect a microphone to the IP camera.
4. S D Card Slot
User can insert a micro SD card into this slot for event recording.
5. R J-45 LAN Socket
The LAN socket is a RJ-45 connector for connections to 10/100Base-TX
Fast Ethernet cabling. This Ethernet port built N-Way protocol can
detect or negotiate the transmission speed of the network automatically.
Please use CAT-5 cable to connect the IP camera to a 100Mbps Fast
Ethernet network switch or hub.
6. F actory Default Reset
This button is used to restore the all factory default settings.
Sometimes restarting the device will make the system back to a normal
state. However, if the system still got problems after restart, user can
restore the factory default settings and install it again.
Restore the device:
a. Insert the paper clip or other tool and press and hold the button
down continuously.
b. Hold it at least 5 seconds and release the tool. Then the device has
been restored to default settings and reboot again.
7. D I/DO Connector
The Camera provides a terminal block with 4 pins of connectors for DI
and DO. Please refer to the user's manual for more information. The
pin 1 is located at the right side of terminal block from rear view.
2.7.3 ICA-H610 Installation
Ceiling Mount
1. Fix the IP camera to L-type bracket with the two supplied screws.
2
Advertisement
Table of Contents
