Table of Contents
Advertisement
4. R eset Button
This button is used to restore the all factory default settings.
Sometimes restarting the device will make the system back to a normal
state. However, if the system still got problems after restart, user can
restore the factory default settings and install it again.
Restore the device:
a. Press the button down continuously.
b. Hold the button at least 5 seconds and release it. Then the device
has been restored to default settings and reboot again.
5. P ower Jack
The input power is DC 12V.
1. ONLY use package power adapter supplied with the
internet. Otherwise, the product may be damaged.
2. The power adapter is unnecessary when internet
camera is connected to a PoE switch. Otherwise, the
product may be damaged when internet camera is
Note
connected to a PoE switch and power adapter simul-
taneously.
6. M IC in (audio in)
Connect a microphone to the IP camera.
7. L ine out (audio out)
Connect a loud speaker to the IP camera. This is for voice alerting and
two-way audio.
2.6.3 ICA-HM350 Installation
1. Fix IP camera to desired location with wall mount fixture
2. Plug-in Ethernet Cable into RJ-45 connector
Connect an Ethernet cable to the LAN socket located on the IP
Camera's back panel and attach it to the network.
3. Connect RS485 D+ and D- (if you need to control PT scanner)
4. Connect the attached power adapters to IP camera and heater
(option) and plug-in these adapters into power outlet
5. Done
2
Advertisement
Table of Contents
