Setting The Clock; Microwave Power Levels - Sharp R-85ST Operation Manual

R-85ST English 20/01/2005
There are two setting modes: 12 hour clock and 24 hour clock.
1. To set the 12 hour clock, press the CLOCK
SETTING key once, as in Step 1 opposite.
2. To set the 24 hour clock, press the CLOCK
SETTING key twice, as in Step 2 opposite.
Example: To set the 24 hour clock to 23:35:
1. Choose the 24 hour clock
by pressing the CLOCK
SETTING key twice.
4. Set the minutes:
Press 10 MIN key three times.
Press 1 MIN key five times.
x3
NOTES:
1. Press the STOP key if you make a mistake during
programming.
2. If the oven is in cooking or minute timer mode and
you wish to know the time of day, touch the
CLOCK SETTING key. As long as your finger is
touching the key, the time of day will be displayed.
3. If the electrical power supply to your microwave
oven is interrupted, plug in the oven again, then
open and close the door. The display will show
"ENERGY SAVE MODE".
Your oven has 5 power levels. To choose the power level, follow the advice given in the cookbook.
900 WATT = 100 % output
630 WATT = 70 % output
450 WATT = 50 % output
• To set the power, touch the MICROWAVE POWER LEVEL key until the desired level is displayed.
• If the MICROWAVE POWER LEVEL key is touched once,
level, continue touching the MICROWAVE POWER LEVEL key until you reach the level again.
• If the level is not selected, the level 900 W (100 %) is automatically set.
16:32 Page 9
2. Set the hours:
Press the 10 MIN key twice.
Press the 1 MIN key three times.
x2
5. Start the clock.
x5

MICROWAVE POWER LEVELS

SETTING THE CLOCK

Step 1.
x1
x2 x3
x1
If this occurs during cooking, the programme will
be erased. The time of day will also be erased.
4. When you want to reset the time of day, follow the
above example again.
5. If you do not set the clock, press the STOP key
once will appear on the display. When the
operation of the oven is finished,
reappear on the display instead of the time of day.
6. If you set the clock, energy save mode does
not work.
270 WATT = 30 % output
90 WATT = 10 % output
will be displayed. If you miss your desired
9
Step 2.
x2
3. Change from hours to mins
by pressing the CLOCK
SETTING key once.
x1
Check the display.
will