Table of Contents
Advertisement
Getting Started with HC15
Confidential / Preliminary
5
Appendix II
This chapter refers to the DSB75 Board and the adapter board needed to mount a HC15
module onto the DSB75 Board.
The focus is on the configuration of several switches you may be required to change for use
with HC15. A detailed description of the DSB75 Board is given in [3].
Please check that all slide switches (S100 – S103) on your HC15-DSB75 adapter board are
set as shown in Figure 3.
Figure 4 shows the DSB75 Board and provides an overview of the connectors and switches
relevant for HC15. Please note that the factory settings of the DSB75 Board are not fully
applicable to HC15. The switches marked red or yellow must be set as shown. The switches
marked green need not be changed.
HC15_startup_v01
Figure 3: HC15-DSB75 adapter board – switch settings
Page 30 of 31
s
80-pin header
X106, X107: Do not use
X104: 50-pin board-to-board
connector for HC15
2007-01-22
Advertisement
Table of Contents
