Frigidaire Electric Patio Grill Use & Care Manual

Frigidaire Electric Patio Grill Use & Care Manual

30" stainless steel outdoor grill with electric ignition


Quick Links

Grill Assembly
Built-In Instructions


Table of Contents

Summary of Contents for Frigidaire Electric Patio Grill

  • Page 1 Grill Assembly Built-In Instructions 5-12 13-15 16-19 21-22...
  • Page 2: Welcome & Congratulations

    Welcome & Congratulations Congratulations on your purchase of a new gas grill! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number one priority. We know you’ll enjoy your new gas grill and Thank You for choosing our product.
  • Page 3: General Safety Instructions

    General Safety Instructions IMPORTANT SAFETY INFORMATION Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.
  • Page 4 Grill Features: FD30 Roll top grill hood Grilling/Cooking surface Side Shelf Control knob: back infrared burner Control knobs: main burners Convection vents Handle Warming shelf Infrared back burner Electronic ignitor: main, rear infrared & side burner Cart w/doorr Ignitor access opening Side Burner Control knob: Side Burner...
  • Page 5: Grill Components List

    Grill Components List Cart Parts L-shaped side pieces U-shaped back side piece Base Wheel channels Cart Door Parts Door handle kit Nylon bushing Door pivot screw and nut Grill Parts Stainless steel grill head Stainless steel side shelf Side burner (side shelf) Electronic ignitor Flavor grids Stainless steel bar grates...
  • Page 6: Grill Assembly

    Note: Prior to assembly remove protective film from stainless steel parts Assembly requires: 4 tools and a Friend Tools required: Power screwdriver Screwdriver extension 1/4” socket wrench 1/2” socket wrench adjustable wrench scissors Caution: Gas regulator is not flush with bottom.
  • Page 7 Attaching Grill Head to Cart While keeping the Grill on the foam base lean it onto its back. (be sure to hold the hood shut when doing this.) With the Grill on its back, loosen all 4 bolts on the bottom side of the Grill, but do not remove.(See Fig.
  • Page 8 Installing the Cart Door Handles Using a 5/32” allen wrench insert 1 screw through the inside of the door front into a bar handle end and tighten securely. (See Fig. 9) Insert Bar Handle into the End Cap attached to the door and then into the other End Cap and tighten End Cap with allen wrench and screw.
  • Page 9 Side Shelf Attachment Attach the shelf to the left side of grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with grill. (See Fig. 13) Lock the shelf in place by inserting (2) self taping screws into shelf.
  • Page 10: Side Burner Assembly

    Side Burner Assembly Attach the Side Burner to the grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with the grill (See Fig. 19) Lock the Side Burner in place by re-inserting (2) hex head screws in the front &...
  • Page 11: Ignitor Assembly

    Side Burner Assembly SIDE BURNER PARTS ASSEMBLY Install grate over burner (See Fig. 23) LEAK TESTING Make sure all burners are turned to “OFF”. Turn on the gas at the cylinder (LP models) or main valve (Natural models). DO NOT turn on the side burner.
  • Page 12: Built-In Instructions

    Built-In Instructions The Frigidaire Grill can be installed as a built-in Grill. If installed as a built-in Grill, the Grill surround must be constructed of Non-combustible material. Planning and Design Start by identifying the number and size of components you want to include: Grill, side burner, access doors for storage or other items you may wish to furnish such as: refrigerator, sink, warming drawer.
  • Page 13 Side cutout is needed on left side to feed ignitor wire to the ignitor plate (26” model only) (Size: 10” high x 5” long, set 1” back from front edge) GFI Electrical outlet for rotisserie motor (6.5 amp min.) *Required Ignitor cutout for front or side mount (26”...
  • Page 14: Gas Requirements

    Gas Requirements General Information Verify the type of gas supply to be used, either Natural Gas (NG) or Liquid Propane (L.P)., and make sure the marking plate (located on the back of the unit) agrees with that of the supply. Note: Never attach an unregulated gas line to the appliance.
  • Page 15 L.P. Gas Installation Frigidaire Gas Grills that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). This assembly is designed to connect directly to a standard 20 lb.
  • Page 16: Leak Testing

    General Information Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.
  • Page 17: Using The Grill

    Grill Location Do not use the grill in garages, breezeway, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface.
  • Page 18: Lighting The Grill

    Before Lighting Warning: Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting. Grill Burner Lighting Lighting the Grill with electronic ignitor Always open the lid before attempting lighting.
  • Page 19: Using The Rotisserie & Side Burners

    Using the Rotisserie & Side Burners (Optional ROTISSERIE KIT to use with Back Infrared Burner must be purchased separately) The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat is magnificent for searing in the natural juices and nutrients found in quality cuts of meats.
  • Page 20 Using the Rotisserie & Side Burners Rotisserie Lighting Open the lid. Push and turn the control knob counter clockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic ignitor button. You’ll hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes before trying again.
  • Page 21: Care And Maintenance

    Care and Maintenance Drip Tray The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. Note: Allow the drip tray to cool before attempting to clean. Cooking Grates The cooking grates can be cleaned immediately after cooking is completed and after turning off the flame. Wear a barbecue mitt and scrub the cooking grates with a damp cloth.
  • Page 22: Troubleshooting

    General Trouble Shooting You should inspect the burners at least once a year or immediately if any of the following conditions occur: The smell of gas in conjunction with the burner flames appearing yellow. The Grill does not reach temperature. The burners make a popping noise.
  • Page 23 Problem Flame is erratic Flare-Ups Burner flame is yellow or orange, in conjunction with the odor of gas. Cart door does not align properly with cart Spider and Insect Warning Spider and insects can nest in the burners of this or any other Grill and cause the gas to flow from the front of the burn- er.
  • Page 24: Limited Lifetime Warranty

    LIMITED LIFETIME WARRANTY Frigidaire Grills have a Lifetime Warranty on all stainless steel panels, 15 years on stainless burners and a 5 year warranty on all other parts. IMPORTANT: We recommend you return the warranty registration card so that you can be contacted with any questions of safety arise that could affect you.

This manual is also suitable for:


Table of Contents

Save PDF