Using The Adaptec Raid Utility; Installing The Raid Driver During Os Installation - Supero A+ SERVER User Manual

4. After exiting the BIOS Setup Utility, the system will reboot. When prompted
during the startup, press the <CTRL+A> key when prompted to run the Dot-
Hill RAID Utility program (see Figure 5-7).

Using the Adaptec RAID Utility

The Adaptec® RAID Utility program is where you can defi ne the drives you want
to include in the RAID array and the mode and type of RAID.
Figure 5-7.Adaptec RAID Utility Program Screen

Installing the RAID Driver During OS Installation

You may also use the procedure below to install the RAID driver during the Window's
OS installation:
5. With the Windows OS installation CD in the CD-ROM drive, restart the
system.
6. When you see the prompt, hit the <F6> key to enter Windows setup.
7. Eventually a blue screen will appear with a message that begins "Windows
could not determine the type of one or more storage devices . . ." When you
see the screen, hit the <S> key to "Specify Additional Device", then insert the
driver diskette you just created into the fl oppy drive.
8. Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the
<Enter> key.
Chapter 5: Advanced Serverboard Setup
5-27