Bypass Copying On Non-Standard Size Paper - Toshiba e-STUDIO202L Operator's Manual

3.Bypass Copying (Cont.)

Bypass copying on non-standard size paper

Non-standard size paper should be within the following ranges:
A (Length): 3.9" to 11.7", B (Width): 5.8" to 17"
2
1
Place some sheets of paper with their
copy side down on the bypass tray. Align
the side guides to the paper length while
holding A.
• The message "Ready for bypass feeding" appears.
• Rear side of the side guides of the bypass tray has an indicator
for paper height. The height of the sheets must not exceed this
indicator.
• When you use more than one sheet, fan the sheets well before
setting them on the tray.
• Do not push the sheets into the entrance of the bypass feeder; it
may cause a paper jam.
When the paper size is larger, draw out the three-stage paper
holder. Raise B when you use LD or a larger size of paper.
2
Place the original on the original glass.
82
2.HOW TO MAKE COPIES
A
B
A
B