Toshiba e-STUDIO202L Operator's Manual page 70

2.Making Copies (Cont.)
4
Press the [START] button.
Copying starts.
•
2
When you copy by placing originals on the original glass (e.g.
using the sort mode, or making 1-sided original 2-sided copies),
the data of these originals are scanned into the memory. In this
case, proceed to steps 5 and 6.
5
Place the next original, and press the [START] button.
• Data scanning of this original starts.
• The next original will also be scanned in the same manner when you press the [YES] button on the touch panel
and then press the [START] button on the control panel.
• Repeat the above procedure until the scanning of the last page of the original finishes.
6
When scanning of all pages has finished, press the [FINISHED] button
on the touch panel.
• Copying starts. The paper exits with its copied side down.
• When the drawer runs out of paper during copying, the corresponding drawer on the touch panel and the [JOB
STATUS] button on the control panel blink. Add paper to this drawer or select another one with the same paper
size.
• Be careful because the paper exit area and paper just after exiting are hot.
68
2.HOW TO MAKE COPIES