Error Code - Toshiba e-STUDIO202L Operator's Manual

6. Error Code

If an error occurs while using the optional printer, optional Fax, optional Internet Fax or optional scan, the
error code is displayed in the status of each log. Take an appropriate action with reference to the following.
Fax / Internet Fax

Error code

Fax
0012
0013
0020
0030
0033
0042
0050
0053
00B0 - 00B5
00C0 - 00C4
00D0 - 00D2
8
00F0, 00F1
00E8
Internet Fax
1C10
1C11
1C12
1C13
1C14
1C15
1C20
1C21-1C22
262
8.JOB STATUS
Problem
Original jam
Door open
Power interruption
Reset
Polling error
Memory full
Line busy
Security mismatch in
relay or mailbox trans-
mission
Signal error or line
condition error
HDD error
System access abnor-
mality
Insufficient memory
Message reception
error
Message transmission
error
Invalid parameter
Exceeding file capacity Ask your administrator to change the "Fragment Page Size" set-
System management
module access abnor-
mality
Job control module
access abnormality
Clear the jammed original.
Firmly close the open door.
Check the power interruption report.
Transmission is cancelled. (The transmission is terminated by
the jammed printing paper during the Direct Transmission.)
Check polling options setup (Security code, etc.), and check if
the polling document exists.
Make sure that there is sufficient memory before making the call
again.
Retry communications.
Confirm the remote party's security code, system password,
and your setup.
Retry communications. Frequent failures may indicate a phone
line problem. If possible, move the unit to another line and try
your communications again.
Retry communications.
Turn the power OFF and then back ON.
Perform the job in error again. If the error still occurs, contact
your service representative.
When there are running jobs, perform the job in error again after
the completion of the running jobs. If the error still occurs, turn
the power OFF and then back ON, and perform the job again.
Turn the power OFF and then back ON.
Perform the job in error again.
Turn the power OFF and then back ON.
Perform the job in error again.
When a template is used, form the template again. If the error
still occurs, turn the power OFF and then back ON, and perform
the job again.
ting for the Internet Fax setting, or reduce the number of pages
and perform the job again.
Turn the power OFF and then back ON.
Perform the job in error again. If the recovery is still not com-
pleted, contact your service representative.
Turn the power OFF and then back ON.
Perform the job in error again. If the recovery is still not com-
pleted, contact your service representative.
What to do