Original Exit/Reverse Motor Drive Section - Toshiba MR-3022 Service Manual

3.1.4

Original exit/reverse motor drive section

Exit/reverse motor
When the data of the original have been scanned, the original is exited to the original exit tray by the
exit/reverse roller driven by the exit motor (shown in a solid line in the figure).
In the duplex scanning mode, the gate solenoid is turned ON and the reverse flap is lowered to switch
the transport path to the reverse tray side when the scanning of one side of the original is completed.
When the reverse flap is lowered, the original is temporarily transported to the reverse tray, and then
the exit motor rotates reversely to return the original to the transport path switched for reverse operation
(shown in a dotted line in the figure).
The reversed original is aligned with the reverse registration roller, and then the other side of the origi-
nal is scanned. When the scanning is completed, the original is exited to the original exit tray.
MR-3018/3020/3021/3022
DESCRIPTION OF OPERATIONS
Gate solenoid
Reverse flap
Exit
Exit/reverse roller
Reverse
Fig. 3-4
© 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 4
06/09