Table of Contents
Advertisement
4
BitStorm 4800 Express Model 4821-A2 Installation Guide
U.S. Government Users. The Software is a "commercial item" as defined at
48 C.F.R. 2.101, consisting of "commercial computer software" and
"commercial computer software documentation" as such terms are used in 48
C.F.R. 12.212. Under 48 C.F.R. 12.212 and 48 C.F.R. 227.7202-1 to
227.7202-4, U.S. Government Users acquire the Software only with the rights
set forth therein.
Third Party Licensors. This Zhone End User License Agreement may be
accompanied by differing or additional provisions applicable to portions of
the Software provided by one or more Licensors ("Licensor Provisions").
User acknowledges and agrees that its Use of such portions of the Software is
subject to the Licensor Provisions.
!
Important Safety Instructions
1 Read and follow all warning notices and instructions marked on the
product or included in the manual.
2 This product is intended to be used with a 3-wire grounding type plug —
a plug that has a grounding pin. This is a safety feature. Equipment
grounding is vital to ensure safe operation. Do not defeat the purpose of
the grounding type plug by modifying the plug or using an adapter. Prior
to installation, use an outlet tester or a voltmeter to check the AC
receptacle for the presence of earth ground. If the receptacle is not
properly grounded, the installation must not continue until a qualified
electrician has corrected the problem.
If a 3-wire grounding type power source is not available, consult a
qualified electrician to determine another method of grounding the
equipment.
3 Slots and openings in the cabinet are provided for ventilation. To ensure
reliable operation of the product and to protect it from overheating, these
slots and openings must not be blocked or covered.
4 Do not allow anything to rest on the power cord and do not locate the
product where persons will walk on the power cord.
5 Do not attempt to service this product yourself, as it will void the
warranty. Opening or removing covers may expose you to dangerous high
voltage points or other risks. Refer all servicing to qualified service
personnel.
6 General purpose cables are described for use with this product. Special
cables, which may be required by the regulatory inspection authority for
the installation site, are the responsibility of the customer. To reduce the
risk of fire, use a UL Listed or CSA Certified, minimum No. 26 AWG
2
(0.128 mm
) telecommunication cable, or comparable cables certified for
use in the country of installation.
7 When installed in the final configuration, the product must comply with
the applicable Safety Standards and regulatory requirements of the
country in which it is installed. If necessary, consult with the appropriate
regulatory agencies and inspection authorities to ensure compliance.
4821-A2-ZN21-30
Advertisement
Table of Contents
