Table of Contents
Advertisement
Mounting Configurations
Mounting Brackets
Installing the Brackets for Rack Mounting
4821-A2-ZN21-30
Three basic installation configurations are available:
Rack mount – see
Installing the Brackets for Rack Mounting on page 17
and
Installing the BitStorm 4800 Express Into a Rack on page
Wall mount – see
Installing the BitStorm 4800 Express on a Wall on
page
21.
Shelf or desktop – see
Desktop on page
23.
Your BitStorm 4800 Express can be installed in a rack or on the wall using
mounting brackets. Two brackets suitable for a 19-inch (483 mm) rack
(marked EIA-19) and two brackets suitable for a 23-inch (584 mm) Bay
Networks or Nortel rack (marked with Paradyne Part Number
868-6282-0020) are shipped with the unit. Two brackets suitable for a 21-inch
(535 mm) rack (marked ETSI) are available from Paradyne as a separate
feature (see
Appendix B-, Equipment
Rack-mounting brackets may also be used to attach the unit to a wall.
NOTE:
In this guide, the term rack refers to any rack, cabinet, frame, or bay
suitable for mounting telecommunications equipment.
To install the mounting brackets for rack mounting:
1 Locate the black screw nearest the front panel on each side of the unit, as
shown.
2 Remove these two black screws (one from each side) before attempting to
install the mounting brackets.
Installing the BitStorm 4800 Express on a Shelf or
List).
BitStorm 4800 Express Model 4821-A2 Installation Guide
Mounting Configurations
19.
17
Advertisement
Table of Contents
