Échelon™ Door Adjustment - U-Line Echelon CO2075FF Service And Parts Manual

Design Features Performance
ÉCHELON™ DOOR ADJUSTMENT
All Échelon™ model doors are aligned at the factory before shipment. Occasional re-adjustment may be
necessary, especially if an Overlay Panel is installed. The following procedure will correct for up to 1/4"
alignment.
The door should never be flush with the top of the cabinet. Even when level, the top edge of
the door will be 1/8" below the top of the cabinet (see Figure 1).
To adjust door:
1. Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the
type (up or down) of adjustment needed.
2. Remove the top hinge pivot pin with a 7/64" hex wrench (see Figure 2) and lift door off bottom hinge
pin. Be careful not to lose door closer inserts (see Figure 5).
Note: The hinge plate on some Échelon™ models does not
have the holes slotted for adjustment. New hinge
plates are available from U-Line Customer Service.
3. With door upside-down, inspect the bottom hinge plate
mounting holes.
a. If your plate has slotted mounting holes, loosen
but do not remove the two hinge plate screws.
b. If your plate does not have slotted mounting
holes, remove the old plate and install the new
plate with the notch to the inside of the door
(see Figure 3).
IMPORTANT
1/8"
GENERAL INFORMATION
Figure 1
11
DOOR001
Figure 2
UL310