U-Line Echelon CO2075FF Service And Parts Manual page 99

INTRODUCTION
The diagnostic LED shown below will specify the following:
1. One Flash -
2. Two Flashes -
3. Three Flashes - Indicate the unit has both failure conditions above.
Note: Interrupting power to the board is the only method of clearing the error codes. Switching off the
ON/OFF/CLN switch does not clear the codes.
CLR2060 BOARD
Part# 68003
COMPRESSOR
WATER
VALVE
HOT H O
2
FAN
GAS PUMP
Indicates the overflow protection circuit is open (only on P-60 pump equipped
units).
Indicate an open thermistor or out of range (too warm) problem.
This LED will
be used to display
error codes.
Not a relay
E_SP-003
98
Design Features Performance