Table of Contents
Advertisement
USER GUIDE
Door Adjustments
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or is not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost may form in the interior.
NOTICE
Properly aligned, the door's gasket should be
firmly in contact with the cabinet all the way
around the door (no gaps). Carefully examine the
door's gasket to ensure that it is firmly in contact
with the cabinet. Also make sure the door gasket
is not pinched on the hinge side of the door.
To align and adjust the door:
1.
Loosen (do not remove) top and bottom hinge screws
using a Philips screwdriver on the top and a 1/4"
socket on the bottom.
2.
Align door squarely with cabinet.
3.
Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4.
Tighten bottom hinge screws.
5.
Tighten top hinge screws.
REVERSING THE DOOR
Location of the unit may make it desirable to mount the
door on the opposite side of the cabinet.
The hinge hardware will be removed and reinstalled on the
opposite side of the cabinet.
TO REVERSE THE DOOR
Remove grille:
Remove the grille (see GRILLE INSTALLATION section of
this guide).
Door Adjustments
Remove arrow clips:
1.
With a puddy knife or other flat tool, gently pry each
arrow clip from hinge mounting holes.
2.
Set aside arrow clips to be reused on the opposite
side.
Remove top hinge and door:
1.
Hold door to keep it from falling.
2.
Remove top hinge from cabinet using a Philips
screwdriver to remove three screws.
3.
Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
4.
Use a Philips screwdriver to remove pivot screw and
reinstall on the opposite surface of the hinge.
Top Hinge
Left Side
5.
Install arrow clips in holes.
15
Top Hinge
Right Side
Pivot
Screw
Advertisement
Table of Contents
