U-Line Echelon CO2075FF Service And Parts Manual page 13

GENERAL INFORMATION
4. If door edge opposite the hinges needs to move up, move plate toward outside of door. If door edge
needs to move down, move plate toward inside of door (see Figure 3). Repeat until top edge of door is
parallel with top of cabinet and tighten screws securely.
SLOTTED
MOUNTING
HOLES
RAISE
OUTSIDE
DOOR EDGE
5. If you have an older model, you must slot the door frame to accommodate the door closer boss. Using
the bottom hinge plate pivot hole as a guide, slot the frame hole by using an 11/32" drill.
SLOTTED
MOUNTING
HOLES
RAISE
OUTSIDE
DOOR EDGE
6. After adjustment is complete, remove the door closers from the bottom hinge,
clean thoroughly and apply petroleum jelly to the mating surfaces of the
closers (see Figure 5). Be sure that bosses on closers align with holes in
hinge and hinge plate. Mount door and install top hinge pivot pin.
NOTCH
ALL MODELS
EXCEPT WINE CAPTAIN
LOWER
OUTSIDE
DOOR EDGE
NOTCH
ALL MODELS
EXCEPT WINE CAPTAIN
LOWER
OUTSIDE
DOOR EDGE
RAISE
OUTSIDE
DOOR EDGE
Figure 3
RAISE
OUTSIDE
DOOR EDGE
Figure 4
12
Design Features Performance
SLOTTED
MOUNTING
HOLES
ALL WINE
CAPTAIN MODELS
LOWER
OUTSIDE
DOOR EDGE
SLOTTED
MOUNTING
HOLES
ALL WINE
CAPTAIN MODELS
LOWER
OUTSIDE
DOOR EDGE
DOOR
CLOSER
INSERTS
BOSS
Figure 5
DOOR003
DOOR003
UL312