Ice Thickness Adjustment - U-Line Echelon CO2075FF Service And Parts Manual

Design Features Performance

ICE THICKNESS ADJUSTMENT

The CLR2060 Clear Ice Maker uses advanced technology to make ice that is crystal clear. This technology
cascades a flow of water over a chilled ice mold that is mounted vertically so no water sits in it. Because
of this ice making technology, clear ice cubes differ significantly from regular ice cubes. Differences are as
follows:
• Dimples. U-Line clear ice cubes have "dimples" on one side from
the cascading water process.
• Cube Variations. Cubes made from different batches,
or even cubes within the same batch may have varying
dimples, thicknesses and/or sizes due to the cascading
water process.
• Cube "slabbing". The U-Line clear ice maker makes a
"slab" of ice that falls from the vertical mold relying on
gravity to break the ice bridges. Depending on the
control setting, and the fullness of the ice
bucket, it maybe necessary to tap the ice
slab with the scoop to break it apart.
The ice cube thickness control is factory set for best overall performance. The factory setting is designed to
maintain an ice bridge of approximately 1/16" to 1/8" under normal conditions resulting in a dimple of
approximately 1/4" to 1/2" in depth (see Figure 2). A fuller cube with less of a dimple results in a thicker
ice bridge. As the ice bridge becomes thicker, the tendency for the cubes to stay together as a slab increases.
A bridge thicker than 1/8" may cause cubes to overfill the ice bucket.
1/4" TO 1/2"
DIMPLE
1/16" TO 1/8"
ICE BRIDGE
GOOD
ICE BRIDGE
Figure 1
BRIDGE
TOO THIN
DIMPLE
TOO DEEP
Figure 2
101
CLR2060 MODEL
DIMPLES
ICE001
BRIDGE
TOO THICK
LITTLE OR
NO DIMPLE
BAD
ICE002