Table of Contents
Advertisement
3.13 Finishing Up
Before placing the top cover back and
secure it screws, make sure that
1.
The connector of the real fan to has
been plugged to FAN 2 pin header
on the motherboard
2.
All cables have been connected
correctly and properly
Now, you can plug the AC power cord to
the system and start to boot it up..
Congratulations on making it this far! You have finished setting up the hardware aspect
of your computer. Before closing up your chassis, make sure that all cables and wires
are connected properly, especially cables and most importantly, jumpers. You may
have difficulty powering on your system if the motherboard jumpers are not set
correctly. For detailed M/B jumper settings, please refer to TYAN Thunder K8S S2880
Motherboard User's Manual bundled here with this barebone system.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please find
setup information and documentation online at our website or by calling your vendor's
support line.
24
http://www.tyan.com
Plug the real
fan connector
to FAN 2 pin
header on the
MB
Advertisement
Table of Contents
