3.9 Installing the Riser Card and PCI Add-on Card
Installing PCI Riser Card & Retention Bar
1.
Insert the bundled 64-bit PCI riser
card into the PCI_1 expansion slot
2.
Place the PCI retention bar above the
riser card and secure it with 2 screws
at both ends to the central strut and
the chassis back panel.
Installing PCI Add-On Card
1.
Unscrew and remove the chassis
angled bracket (See picture indicated
in circle on right)
2.
Slide in and insert the PCI add-on
card to the expansion slot on the riser
card
3.
Position and screw the angled bracket
back in place.
Detach the angled bracket at
chassis rear first; then, screw it
back in place after securing the PCI
add-on card
20
http://www.tyan.com
PCI_1
64-bit/133MHz
PCI-X bus
Central Strut
Make sure the
riser card is
snapped and
secured by the
flanges on the
retention bar