Table of Contents
Advertisement
3.7 Installing and Connecting Power Distribution Board (Pre-Installed)
Picture of the Power Distribution Board
8-pin power
connector
(Power out to Motherboard)
1.
Connect power cables to the power
riser board
2.
Lay the power distribution board on
top of the SCA backplane with
connector side downward.
3.
Use 10 flat-head screws to secure the
power riser board
4.
Then you can attach the two power-in
cables to motherboard. (See picture
on right)
24-pin power
connector
Picture (right):
Installed and
connected
power
distribution
board
18
http://www.tyan.com
24-pin power
connector
(Power in from Power
S
l )
SCA backplane
beneath
8-pin power
connector
Advertisement
Table of Contents
