Grounding Instructions; Power Cord Replacement; Precautions To Avoid Possible Exposure To Excessive Microwave Energy; Rf Interference Considerations - TurboChef ENCORE Owner's Manual

ii SAFETY INSTRUCTIONS

GROUNdING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This oven is equipped with a cord that has
a grounding wire with a grounding plug, which must be plugged into an outlet that is properly installed and
grounded. Consult a qualified electrician or serviceman if uncertain about the ability to follow grounding
instructions or if in doubt as to whether the appliance is properly grounded.
do not use an extension cord. If the power cord is too short, have a qualified electrician or
X
serviceman install an outlet near the appliance.
WArNING: Improper grounding can result in risk of electric shock.

POWER CORd REPLACEMENT

If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly
qualified person.
PRECAUTIONS TO AvOId POSSIbLE ExPOSURE
TO ExCESSIvE MICROWAvE ENERGY
(a) Do not attempt to operate this oven with the door open since open-door operation can result in
harmful exposure to microwave energy. It is important not to defeat or tamper with the safety
interlocks.
(b) Do not place any object between the oven front face and the door or allow soil or cleaner residue to
accumulate on sealing surfaces.
(c) Do not operate the oven if it is damaged. It is particularly important that the oven door close
properly and that there is no damage to the: (1) Door (bent), (2) hinges and latches (broken or
loosened), (3) door seals and sealing surfaces.
(d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel.

RF INTERFERENCE CONSIdERATIONS

This oven generates radio frequency signals. This device has been tested and was determined to be in compli-
ance with applicable portions of FCC part 18 requirements and to the protection requirements of Council
Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic
compatibility at the time of manufacture. However, some equipment with sensitivity to signals below these
limits may experience interference.
If your equipment experiences interference:
Increase the physical separation between this oven and the sensitive equipment.
a
a If the sensitive device can be grounded, do so following accepted grounding practices.
If battery-powered microphones are being affected, ensure that the batteries are fully charged.
a
Keep sensitive equipment on separate electrical circuits if possible.
a
a route intercom wires, microphone wires, speaker cables, etc. away from the oven.
SAvE ThESE INSTRUCTIONS