Table Of Common Issues And Solutions - TurboChef high h BATCH 2 Owner's Manual

I S S u e
Oven is not receiving power.
Oven is not warming up properly
or F8 Fault Code is flashing on the
display.
Oven is not cooking properly.
Fault Code –
F2: Cook Temperature Low
Fault Code –
F6: EC Temp
For additional assistance or if the oven is experiencing a problem not listed above, call Customer Service
at 1-800-90TURBO, +1 214-379-6000, or your Authorized Distributor.
P O S S I B L e S O L u T I O N ( S )
Ensure the oven is plugged in.
o
Verify the wall circuit breaker is on.
o
Reset the breaker and then power up the oven.
o
Follow the deep cleaning procedures (pages 9-10) to
o
remove debris that may be preventing air circulation.
Reset the high-limit thermostat (press the red button
o
on the back of the oven).
Ensure the door is closed.
o
Follow the deep cleaning procedures (pages 9-10) to
o
remove debris that may be preventing air circulation.
Ensure the correct food group and/or food item is
o
selected for the product.
Ensure the product is cooked from the correct
o
starting state (e.g., fresh, frozen, etc.).
Ensure the door is closed.
o
Reset the high-limit thermostat (press the red button
o
on the back of the oven).
Repeat warm-up and allow the oven to idle for five
o
(5) minutes.
Reduce the amount of frozen product being cooked
o
at a given time.
Ensure the temperature around the oven is less than
o
120ºF (49ºC).
Ensure nearby appliances or fixtures are not
o
obstructing airflow into the back cooling fans.
Ensure the cooling fans on the back of the oven are
o
not clogged with debris.
T r O u B L e S H O O T I N G T I P S 21