Registration - Binatone iDECT Freedom Twin User Manual

7.4.6
PBX ACCESS
If you use the phone on a PBX that needs an access digit to get an external
line, a single digit can be set to dial automatically before any Phonebook or
Calls List number.
1. Press <MENU/OK> and <UP/DOWN> to select BS SETTINGS.
2. Press <MENU/OK> and <UP/DOWN> to select
3. Press<MENU/OK> to show CODE, then enter your access digit (1-0) and
press <MENU/OK> to confirm it and activate the feature.
Note: Press <C/MUTE> to delete any access digit, and deactivate the feature.
7.5

Registration

IMPORTANT: When you purchase your phone system, all handsets and the
headset are already registered to your base, so you do not need to register
them.
Handset registration is only necessary when you buy extra handset or if a
handset has become faulty.
You can register additional handsets to have up to five handsets per base unit,
with each handset's number (1 to 5) shown on its display. (Note: each handset
can only be registered to one base.)
7.5.1 To register a new handset to your base:
1. Press and hold <FIND> on the base station for more than five seconds, to
put the base station into registration mode. It will stay in registration mode
for about 1 minute, so the following handset sequence must be completed
within this time.
2. Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
3. Press <MENU/OK> to display PIN?------.
4. Enter the 4-digit system PIN(default0000).
5. Press <MENU/OK> to confirm, and the display will show PLEASE WAIT.
If the handset registration is successful, you will hear a confirmation tone and
the <antenna icon> will stop flashing.
The handset will automatically be allocated the next available handset number.
This handset number is shown in the handset display in standby mode. If the
handset registration is unsuccessful, the <antenna icon> will still flash.
PBX ACCESS.
25