Installation And Set-Up; Install Rechargeable Batteries Into The Handset; Connecting The Mains Power Supply - Binatone iDECT C5i System User Manual

Install rechargeable batteries into the handset

1
Install the two Ni-MH, AAA size, rechargeable batteries into the handset in
accordance with the polarity markings in the battery compartment.
2
Close the battery compartment cover by sliding it into place and pressing firmly to
make sure that it is secure.

Connecting the mains power supply

1
Plug the base power cord into the power jack at the bottom of the base unit and
connect the other end to a 100-240Vac 50-60Hz electrical outlet.
2
Plug the telephone line cord into the phone jack at the bottom of the base unit
and connect the other end to a telephone wall socket.
3
Connect the charger adaptor to a 100-240Vac 50-60Hz electrical outlet.
Notes:
• Before you use the cordless handset for the first time, it is important to charge
the batteries fully.
• Leave the handset on the charging cradle for 15 hours.
• The battery charge icon will scroll when you are charging the battery.
• If the icon is not showing the correct battery charge level, first verify that the
handset is correctly placed in the charging cradle. If it is placed correctly, try to
remove and re-install the batteries. Please note that it is normal for the mains
adaptor to become warm - this does not indicate a fault.
CAUTION: Use only the power adaptors that are supplied with this unit. Using
other power adaptors may damage the unit.
4

Installation and Set-up