Table of Contents
Advertisement
o Alter the spin speed, if required, using the spin speed control
knob (H) or change the wash temperature by using the wash
temperature control knob (I).
o Press the Start / Pause button (C).
o After approximately 5 seconds, you will hear your washing
machine start the wash cycle.
o If there is a power failure or the plug is pulled out of the
socket when a wash cycle is in progress, once power has
been restored, the wash program will continue.
o Whilst the wash program is in progress, the time remaining to
the end of the wash cycle will appear on the display.
Cancelling or pausing a wash program
o To stop a wash program once a wash cycle is in progress, you
should press and hold the Start / Pause button (C) for about 2
seconds.
o To cancel the program, turn the program selection knob (K) to
the OFF position.
o If you wish to add or remove items the door will remain locked
for two minutes before it is possible to open the door.
o Close the door and press the Start / Pause button (C) to
continue the wash cycle.
Before opening the porthole door, you MUST
drain the appliance; otherwise there may still
be water in the drum when you open the
door.
Delay start feature
Your appliance has a delay start feature, which allows you to pause
the start of a wash cycle until a later time. You can delay the start
time by 3, 6 or 9 hours.
o Follow the process listed under "Selecting a wash program".
o Before pressing the Start / Pause button (C), you should select
the length of time that you want to delay the wash program for
by pressing the delay start button (D). The relevant LED will
light on the display to show the set delay time.
20
Advertisement
Table of Contents
