Barco Color Coronis 2MP System Manual page 31

Display Controller installation
2. Remove the chassis cover according to the
manufacturer's instructions. Be sure to observe
safety warnings.
3. Install the BarcoMed 2MP2CF-3D display controller
into your systems AGP slot. Be sure that the display
controller is seated firmly in the slot.
4. Secure the card to the chassis with the PC's I/O panel
mounting screw, and replace the chassis cover.
5. Connect the primary display to the connector at the
top of the IO panel on the BarcoMed 2MP2CF-3D
display controller using the provided DVI cable (see
figure 5). For a dual-headed BarcoMed 2MP2CF-3D
setup, connect the secondary display to the other
connector on the display controller.
6. Reconnect the power cord, turn on the power, and
boot the system as usual.
System Manual Color Coronis 2MP 31