Figure 2-4. Installing A Hard Drive In The Cover - HP OMNIBOOK 4100 Service Manual

5. If you are installing a new hard drive that does not have a cover, you can remove the cover parts
from the old hard drive:
Remove the screw from the case, then pry open the flap. If necessary, use a flat-blade
screwdriver
Use a flat-blade screwdriver to pry open the snaps at the ends of the case, then open the
connector-side of the case.
Pry out the corner next to the connector, then lift out the connector and hard drive together.
Unplug the internal connector and cable from the hard drive.
Screw, M3×4mm
Reassembly Notes
Caution
Do not cover the vent hole in the top surface of the hard drive or in the case. If you cover the
hole, the hard drive could fail prematurely.
If you install a 9.5-mm hard drive in the case, make sure you install the spacer on top of the
drive. If you install an 8.4-mm hard drive, make sure you stick the end spacer on the case and
install the top spacer on top of the drive.
Pry out the connector corner of the case and insert the external connector and hard drive at the
same time. The connector seats in the lower part of the opening in the case.
Secure the two tabs on the screw flap by inserting the corner tab last, while prying out the nearby
corner of the case.
When you install the battery module, be sure the plastic tab on the hard drive case lays folds up
against the front of the case.
2-6 Removal and Replacement
Spacer for 9.5mm HDD
(see Caution)
HDD cover kit

Figure 2-4. Installing a Hard Drive in the Cover

Spacers for 8.4mm HDD
(see Caution)
HP OmniBook 4100/4150