Avocent Cyclades ACS Command Reference Manual page 128

114 ACS Advanced Console Server Command Reference Guide
Table 6.1: pmMenu and pmCommand Commands (Continued)
Menu Item
Current
Temperature
Humidity
(ServerTech only)
Voltage
(Cyclades IPDU)
Buzzer
(Cyclades IPDU)
Current Protection
(Cyclades IPDU)
Syslog
(Cyclades IPDU)
Version
Factory Default
Reboot
Restore
(Cyclades IPDU)
Save
Alarm Threshold
(Cyclades IPDU)
Command Syntax
current {display|reset}
[<IPDU ID>
[<sensor name>]]
temperature {display|reset}
[<IPDU ID>]
humidity {display|reset}
[<IPDU ID>]
voltage {display|reset}
[<IPDU ID>]
buzzer {status|on|off}
[<IPDU ID>]
currentprotection
{status|on|off}
[<IPDU ID>]
syslog {status|on|off}
[<IPDU ID>]
ver [<IPDU ID>]
factorydefaults [<IPDU ID>] Restore configuration to factory default for a single or all
reboot [<IPDU ID>]
restore [<IPDU ID>]
save [<IPDU ID>]
alarm [<IPDU ID>
[<threshold>
[<sensorname>]]]
Description
Display the amount of current that is running through the
IPDU, or reset the maximum detected current in a single
or all IPDU appliances.
The <sensor name> can be X,Y,Z (Cyclades PM42
IPDU), A,B (PM IPDU with segments) or 1,2
(ServerTech with more than one inlet).
Display temperature on an IPDU, if the IPDU unit is
equipped with a temperature sensor. Reset the
maximum detected temperature in a single or all
IPDU appliances.
Display humidity or reset the maximum detected
humidity in a singe or all IPDU appliances.
Display voltage in a single or all IPDU appliances.
Configure a buzzer to sound when a specified alarm
threshold has reached for a singe or all IPDU
appliances. Options are Status, On to activate or Off
to deactivate.
Enable or disable current protection. This option is to
prevent the outlets from being turned on, if the current
on the IPDU exceeds the specified threshold.
Enable or disable syslogging and alarm notification.
Display the software and hardware version of a single or
all IPDU appliances.
IPDU appliances.
Restart the IPDU applicances in chain.
Restore the configuration saved in Flash.
Save the current configuration in Flash.
Set an alarm notification when the current exceeds the
selected threshold.
The <sensor name> can be X,Y,Z (Cyclades PM42
IPDU), A,B (PM IPDU with segments) or 1,2
(ServerTech with more than one inlet).