Weapon Mounted Operation - ATN PVS-14 Operator's Manual

NOTE
The sharpest image will be observed only when the objective
lens and eyepiece lens are properly focused.
(5) rotate the diopter adjustment for the clearest view of the image
intensifier screen.
NOTE
Any readjustment of eye relief requires readjustment of the
diopter.
(6) adjust the eye relief distance by depressing the side buttons
(Figure 2.21.) (or press down on side lever on metal mount) and
sliding monocular fore or aft to obtain a full field-of-view of the im-
age. reset the diopter adjustment for best image.
(7) adjust the objective lens focus (Figure 2.1.) while observing an
object until the sharpest image is obtained.
(8) to flip up, grasp the helmet tilt and flip-up assembly and rotate
upward and rearward until the latch is firmly engaged.
WARNING
The monocular will not be turned off automatically when
flipped up. The monocular must be turned off by the power
switch.
(9) to flip down, grasp the helmet tilt and flip-up assembly and ro-
tate downward and forward until the latch is firmly engaged.
(10) turn the power switch to the on position to resume viewing.

2.4.4. WEAPON MOUNTED OPERATION

NOTE
The MUNVM can be used in conjunction with a collimated
dot aiming device mounted on the forward mounting rail. The
brightness control for the aiming device should be set at or
near it's minimum setting.
perform the following procedures for weapon mounted operation:
(1) ensure that the battery are installed per paragraph 2.3.2.
(2) assemble the weapon mount to the monocular per paragraph
2.3.11., steps 1 and 2.
2-38