Stun - ATCOM AT-610 User Manual

AT-610 User Manual
Notice Notice Notice Notice：The above configuration can exist at the same time. For example you
enable # as the signal of sending the call while set fixed length of 11. Either you
press # before the number reach 11 or dial 11 digital can send out the call
4.3. 4.3.
4.3. 4.3.

Stun

Stun
Stun Stun
� STUN NAT Transverse：STUN NAT Transverse status true or false
� STUN Server Addr:
� STUN Server Port: configure stun server port default 3478
� STUN Effect Time: stun detect NAT type interval time .If NAT found a link
inactive for a certain time , it will close the link so you need to send a packet
within a interval tome to keep the link alive
Local SIP Port ： config local SIP port , default as 5060Use Stun ：
�
enable/disable SIP STUN
Notice: Notice: Notice: Notice: SIP STUN is used for NAT transverse. When you config STUN
server's address and port (default 3478) and enable it, then you can use the
normal SIP server to make the IP phone transverse NAT.
ATCOM TECHNOLOGY CO., LIMITED
configure stun server address;