Installing A Fsd-804P - Planet FSD-804P User Manual

2.1.3 LED Indicators
LED Color
PWR Green
PoE in use Green
LNK/ACT Green
100 Green
2.1.4 FSD-804P rear panel
The rear panel of the Switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 50/60Hz.
Power Notice:
1. The device is a power-required device, it means, it will not work till it is pow-
ered. If your networks should active all the time, please consider using UPS
(Uninterrupted Power Supply) for your device. It will prevent you from network
data loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect
your switch from being damaged by unregulated surge or current to the Switch
or the power adapter.

2.2 Installing a FSD-804P

This part describes how to install your FSD-804P Fast Ethernet Switch and make
connections to the switch. Please read the following topics and perform the procedures in
the order being presented.
PLANET FSD-804P Fast Ethernet Switch do not need software configuration. To install your
FSD-804P on a desktop or shelf, simply complete the following steps.
2.2.1 Desktop Installation
To install a FSD-804P on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the switch.
Step2: Place the FSD-804P on a desktop or shelf near an AC power source.
Function
Light: Power on
Light: The port is providing 48VDC power
Light: The port is successfully established
Blink: The port is actively receiving or sending the
data
Light: The port is operating at 100Mbps speed
Figure 2-2 Rear Panel of FSD-804P
5