Purifier Housing (Fig - Philips WP3822 User Manual

English
1
 Push the water purifier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 21).
 Screw the attachment nut firmly onto the water purifier housing
(Fig. 22).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.
Installing the filter cartridge
1 Make sure the tap is closed.
 Set the water selection lever to the unfiltered stream
position (Fig. 23).
 Tilt the filter cartridge 90° backwards and insert it into the water
purifier housing. (Fig. 24)
 Pull the cartridge upwards until it is in upright position. (Fig. 25)
5 Air trapped inside the filter cartridge affects the flow rate of the
filtered water. To avoid this, slightly open the tap and let water run
through the filter cartridge for 30 seconds after you install/replace
the filter cartridge. The slow stream of water helps to remove any
air trapped in the filter.
Setting the filter capacity
When you install the first filter, follow the instructions below to activate
the countdown of the filter capacity.
The default filter capacity setting of the water purifier is 1500 litres. The
capacity of the filter cartridge supplied with the WP3822 is 1500 litres.
1 Make sure that the water purifier housing and the filter cartridge
are properly installed.
 Press the filter capacity selection button.
The default filter capacity of 1500 litres flashes on the display for 4
,
seconds and is then shown continuously for another 5 seconds to
indicate that the selected setting has been set.