Philips WP3822 User Manual page 11

 Screw the attachment nut firmly onto the water purifier
housing (Fig. 10).
installation B-type adapter
- For taps with an aerator (threaded on the outside) (Fig. 11).
1 Remove the attachment nut and the adapter from the water
purifier (Fig. 7).
 Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 12).
 Tighten the adapter further with a coin (Fig. 13).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 14).
installation C-type adapter
- For taps with an aerator (threaded on the inside) (Fig. 15).
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 7).
 Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. If water leakage occurs, wind Teflon tape round the
screw thread of the adapter before you screw it onto the
tap (Fig. 16).
 Tighten the adapter further with a coin (Fig. 17).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 18).
installation d-type adapter
- For taps other than A, B or C. (Fig. 19)
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 7).
 Take out the original adapter and screw the D-type adapter onto
the water purifier housing. (Fig. 20)
English
11