Philips WP3822 User Manual page 13

Note: If you see another filter capacity on the display of your water purifier,
press the filter capacity selection button again until the display shows the
capacity of your filter cartridge (2500, 1500 or 900 litres).The selected
capacity flashes for 4 seconds and is then shown continuously for another
5 seconds to indicate that the setting has been set.
Note: When you replace the filter cartridge for the first time and any next
time, reset the filter capacity as described in section 'How to reset the filter
capacity' in chapter 'Replacement'.
using the appliance
1 Turn the water selection lever to the desired setting ('click').
The water selection lever has 3 settings: filtered spray, unfiltered spray
and unfiltered stream. See the sections below.
 Open the tap.
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the water selection lever until the filtered spray symbol is
aligned with the indicator (Fig. 26).
Do not let water hotter than 50°C run through the water purifier at
this setting, as this may damage the water purifier.
If you filter water between 35°C and 50°C, the water may have an
unpleasant smell. The filter cartridge has absorbed this smell during
filtering, but releases it again if you filter water hotter than 35°C.
 Open the tap.
Filtered spray comes out of the water purifier.
,
The display is on and counts down the remaining filter capacity.
,
Note: The LCD display only shows the remaining filter capacity when you use
the water purifier at the filtered spray setting and when the water pressure is
more than the minimum required 0.7kgf/cm² (7 meters of water column/
70kPa).
English
1