Table of Contents
Advertisement
TABLE OF CONTENTS
SECTION
1.0 Warranty Information .............................................................2
1.3 Service Information
2.0 General Information...............................................................4
3.0 Configuration .........................................................................5
4.0 Installation ...........................................................................18
5.0 Operation .............................................................................22
Appendix A - Specifications........................................................33
Appendix C - Terminal Interface Pin Assignments .....................35
Appendix D - Transmission Distance Chart ...............................38
Appendix E - Line Interface Pin Assignments ............................39
1
PAGE
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 1094ARC components to
be free from defects, and will-at our option-repair or replace the
product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials,
and does not cover customer damage, abuse or unauthorized modifi-
cation. If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall Patton Electronics be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or consequen-
tial damages arising from the use of or inability to use this product.
Patton Electronics specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall
be deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 1094ARC generates and uses radio frequency energy,
and if not installed and used properly-that is, in strict accordance with
the manufacturer's instructions-may cause interference to radio and
television reception. The Model 1094ARC has been tested and found
to comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If the Model 1094ARC
does cause interference to radio or television reception, which can be
determined by disconnecting the unit, the user is encouraged to try to
correct the interference by one or more of the following measures:
moving the computing equipment away from the receiver, re-orienting
the receiving antenna and/or plugging the receiving equipment into a
different AC outlet (such that the computing equipment and receiver
are on different branches). In the event the user detects intermittent or
continuous product malfunction due to nearby high power transmitting
radio frequency equipment, the user is strongly advised to take the fol-
lowing steps: use only data cables with an external outer shield bond-
ed to a metal or metalized connector; and, configure the rear card as
shown in section 3.2 of this manual.
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the European Union.
A Certificate of Compliance is available by contacting Technical
Support.
2
Advertisement
Table of Contents
