Advertisement
The Patton Model 537 is simple to install and requires no user
configuration. Follow these installation steps.
1. Disconnect the data cable from the device you are protecting in
a manner consistent with the manufacturer's installation
instructions.
2. Be sure the connector shield on the device you are protecting
is connected to frame ground. If not, contact Patton Technical
Support for further instructions.
3. Plug the connector of the Model 537 directly into the Token
Ring port of the device you are protecting.
4. Re-attach the cable to the available connector on the Model
537. The Model 537 is now inserted between the
data port and the data cable, and will provide up to 1500 Watts
of protection to the data port.
Note: We recommend that a Patton surge protector be
connected to the other end of the data cable as well. To order,
please contact us at: (301) 975-1000; http://www.patton.com;
or, support@patton.com
5.0 INSTALLATION
3
Advertisement
