Advertisement
The Patton Model 542 and 543 are easy to install. The following
instructions will clearly explain each step:
1.
Unplug the existing connection between the coaxial cable and the
CCTV equipment's BNC port for the 542, or the SATV/CATV
equipment's F-Series port for the 543.
2.
Install the Model 542 or 543 between the incoming coax line and
the protected equipment (see below). Place the surge protector as
close as possible to the device being protected.
3.
Connect the braided grounding strap directly to an earth ground
connection on or near the protected device. If you are not sure
where to locate an earth ground connection, consult the
equipment's user manual or contact the manufacturer. This ground
connection is critical for proper operation of the Model 542 or 543.
3.0 INSTALLATION
4
Advertisement
