Configuring Dip Switch S1 - Patton electronics EnviroNET 2100 Series User Manual

EnviroNET User Manual
Configuring DIP Switch S1
DIP switch S1 is where you configure the CopperLink line rate, symmetric or asymmetric, Ethernet full auto
negotiation capability (100Base-T full or half duplex, 10Base-T full or half duplex) or limited auto sense (only
100Base-T half duplex, 10Base-T full or half duplex)
EnviroNET Model 2168
.
Table 10. S1 Summary
Position
S1-1 Ethernet Auto Sense
S1-2 Line Rate
S1-3 Line Rate
S1-4 Line Rate
S1-5 Reserved
S1-6 Reserved
S1-7 Reserved
S1-8 Reserved
Switch toggle
Push toggle up
for ON position
Push toggle
down for
OFF position
Ethernet
Auto Sense
Figure 12. EnviroNET 2168 Dip Switch Settings
3 • Configuring the EnviroNET
Description
S1
ON
1 2 3 4 5 6 7 8
Line Rate
Reserved
28