Download  Print this page

Precautions For Use - Panasonic AJ-PCD10E Operating Instructions Manual

P2 memory card drive
Hide thumbs

Advertisement

Precautions for Use

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
This product is equipped with 2 types of AC mains cable. One is for continental Europe, etc. and the other one
is only for U.K.
Appropriate mains cable must be used in each local area, since the other type of mains cable is not suitable.
FOR CONTINENTAL EUROPE, ETC.
Not to be used in the U.K.
FOR U.K. ONLY
This appliance is supplied with a moulded three pin
mains plug for your safety and convenience.
A 13 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that
the replacement fuse has a rating of 13 amps and that
it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
body of the fuse.
If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used un-
til a replacement cover is obtained.
A replacement fuse cover can be purchased from your
local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE
FOR THE SOCKET OUTLET IN YOUR HOME THEN
THE FUSE SHOULD BE REMOVED AND THE PLUG
CUT OFF AND DISPOSED OF SAFELY. THERE IS A
DANGER OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13 AMP
SOCKET.
If a new plug is to be fitted please observe the wiring
code as shown below.
If in any doubt please consult a qualified electrician.
WARNING:
THIS
EARTHED.
IMPORTANT:
The wires in this mains lead are co-
loured in accordance with the following code:
Green-and-Yellow:Earth
Blue:
Neutral
Brown:
Live
Caution for AC Mains Lead
or the BSI mark
on the
APPLIANCE
MUST
FOR U.K. ONLY
If the plug supplied is not suitable for your
socket outlet, it should be cut off and
appropriate one fitted.
As the colours of the wires in the mains lead of this ap-
pliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as fol-
lows:
The wire which is coloured GREEN-AND-YELLOW
must be connected to the terminal in the plug
which is marked with the letter E or by the Earth
symbol
or coloured GREEN or GREEN-AND-
YELLOW.
The wire which is coloured BLUE must be con-
nected to the terminal in the plug which is marked
with the letter N or coloured BLACK.
The wire which is coloured BROWN must be con-
nected to the terminal in the plug which is marked
with the letter L or coloured RED.
How to replace the fuse
1. Open the fuse compartment with a screwdriver.
2. Replace the fuse.
BE
Fuse
3

Advertisement

Table of Contents
loading

  Related Manuals for Panasonic AJ-PCD10E

This manual is also suitable for:

Aj-pcd10p