Table of Contents
Advertisement
Inserting a P2 Card
When inserting a P2 card into the slot in the
P2 drive, make sure you keep the card
horizontal as you ease it in.
Forcing the card in on an angle may cause
a problem.
Write-protection of P2 Card
A P2 card has a write-protect switch.
Setting this switch to "PROTECT" can
prevent writing and deleting of data.
Note: The write-protect switch is not
effective when the P2 card is inserted in the
P2 drive. Make sure you remove the P2
card from the P2 drive, set the switch, then
re-insert the card, in order to effect the
switch setting.
Installation
There are two ways to connect the P2 drive to a personal computer :
1. Using the P2 drive as an external drive connected to a personal computer
2. Mounting the P2 drive in a 5-inch bay of a desktop personal computer
<Notes>
Connect the P2 drive to a personal computer before installing the P2 driver to the
computer from the installation CD.
For details, refer to the Installation Manual.
The P2 drive is designed for a 5-inch bay. If all file bays are occupied, you will need to
remove one of the built-in drives to make room for the P2 drive.
The P2 drive should be used in a personal computer whose design allows the front panel
of the drive to be manipulated.
8
PROTECT
Setting the write-
protect switch to
"PROTECT" can
prevent writing and
deleting of data.
Setting the write-
protect switch to
this side allows
writing and
deleting of data.
Advertisement
Table of Contents
