Dial Mode Selection - Panasonic EASA-PHONE KX-T30810 Installation Manual

- A= [-%I: to assign the same on all 3 CO's
until the desired dial mode appears
default (all 3 CO's)
[03] [NEXT] [,4] [SELECT] [ME
;3] [NEFT] [NEXT] [SELECT] [MEMORY] [END]
1. _ _ _ _
until the desired CO number appears
S
Allows the user to select the dialing mode (tone
or pulse) on each CO (Central Office) Line.
TONE Dial Mode
The dial signal from the extension (with tone or
pulse dial mode) will be converted to TONE.
TONE will then be transmitted to the Central
Office.
PULSE Dial Mode
The dial signal from the extension (with tone or
pulse dial mode) will be converted to PULSE.
PULSE will then be transmitted to the Central
Of&e.
"CO DIAL MODE" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displayed.
3. Press the NEXT button.
"CO 1: TONE" will be displayed and
"TONE" will blink.
. Press the SELECT
button to alternate be-
tween TONE and PULSE.
5. Press the MEMORY button.
The blinking LCD will stop.
6. Repeat steps 3 to 5, to progrum the diuling
mode on the other central ojjice lines.
7. To return to the initial program mode, press
the END button.
2-Y
When you start the programming from step 1,
you muy dial the desired CO number instead of
the NEXT button at step 3.
The PREV button allows you to see the entry
status in the previous CO dial mode.
If
your extension is not a KX-T30830 or
KX-T30820 but a standard telephone, and the
dial tone frequency
of
CO Lines is 600 Hz, the
KX- T30810 is used
for
only pulse dial mode
of
CO Lines.
If the KX-T30810 is connected to the Central
Ofjcice directly or installed behind a host PBX,
which receives both tone and pulse dialing
mode, the KX-T30810 must be used only in
the tone dial mode.
e
See page 5-14.