Record Your Hard Drive Information; Register Your Drive; Back Up Your Data; Open Your Computer - Western Digital WD SATA Hard Drives Installation Manual

Record Your Hard Drive Information

In the table that follows, write down the serial number, model number, and date code listed
on your new Western Digital SATA hard drive. The complete serial number, model number,
and date code are on the large label at the top of the drive. This information is required for
technical support purposes. See the illustration below for reference.
IMPORTANT: Do not remove, tear, or damage the tape seal or any labels from the drive;
these actions will void the warranty.
Serial Number:
Model Number:

Register Your Drive

Take advantage of Western Digital special offers and product updates by registering your new
hard drive online at https://www.wdc.com/en/products/registration.

Back Up Your Data

Before performing any hardware installation, protect your data by backing up your existing
hard drive before installing your new Western Digital hard drive. Most operating systems
include a backup utility. Refer to your operating system or utilities documentation for
instructions.

Open Your Computer

IMPORTANT: Before handling your system components, discharge static electricity by
touching the metal chassis of your computer or by wearing a grounding strap.
1. Power off the computer.
2. Unplug the power cord.
3. Remove the computer system outside cover (refer to your computer system manual for
instructions).
Date Code:
WESTERN DIGITAL SERIAL ATA HARD DRIVE
INSTALLATION GUIDE
BEFORE GETTING STARTED - 2