Set Up Your Hard Drive; Install A New Boot Drive - Western Digital WD SATA Hard Drives Installation Manual

Set Up Your Hard Drive

This section contains instructions for installing your new Western Digital hard drive either as
a new boot drive or as an additional storage drive.

Install a New Boot Drive

1. Insert the Data Lifeguard Tools CD into your CD-ROM drive.
a) If using the DOS version, restart the computer and boot from the CD.
b) If using the Windows version, the CD autoruns on your desktop.
2. Select Run Data Lifeguard Installation Software from the setup menu.
3. The main menu below appears after Data Lifeguard Tools has loaded. Click on Set Up
Your Hard Drive from the list of available options. Data Lifeguard will take several
moments to scan for all of your system devices.
4. After Data Lifeguard Tools has detected your installed hard drive(s), select the new drive
that you want to format or partition as the new boot drive and click Next. If you are using
a Serial ATA host adapter card, click on the Additional Controllers tab to select your new
drive.
WESTERN DIGITAL SERIAL ATA HARD DRIVE
INSTALLATION GUIDE
DATA LIFEGUARD TOOLS V11.0 - 9