Western Digital WD SATA Hard Drives Installation Manual page 15

8. After Data Lifeguard Tools has completed formatting and partitioning the drive, the setup
summary screen outlines all of the steps completed. Click Done to close or exit.
9. Remove the Data Lifeguard Tools CD from the CD-ROM drive and choose from the
following options:
a) If installing Windows, insert the Windows installation CD to boot from the
CD-ROM drive and restart the system. Follow the on-screen instructions to install the
operating system.
Note: Windows installation will inform you that there is an existing partition on the
drive. Since the drive has been previously set up using Data Lifeguard Tools, you can
bypass this function and proceed directly with Windows installation.
b) If an operating system has already been installed, restart the system.
10. This concludes the hard drive setup process. Your Western Digital hard drive is now ready
to use.
WESTERN DIGITAL SERIAL ATA HARD DRIVE
INSTALLATION GUIDE
DATA LIFEGUARD TOOLS V11.0 - 11