DSC Power608 Instruction Manual page 7

To erase a code:
Enter [ ][5][Master Code][code number 01 to 32][ ]. Press [#] to return to the Ready state. The
Master code cannot be erased.
Programming codes from an LCD Keypad:
Master Code
Press the [ ] key to enter the function list. Scroll (< >) to...
Press [5] or [ ]. The display will read...
Press (*) for <>
Access Codes
Enter your current Master Code. The display will read...
Enter Master
Access Code
"40P" represents the Master Code. Press the [ ] key to indicate that you wish to
(*) to Edit <>
program the Master Code. The display will read...
User Code 40P
Enter the new Master Code. The Master Code must be four digits long, unless
Enter New Code
otherwise indicated by your installer. Enter digits 0 through 9 only. Once the new
1234 <>
code is entered, the keypad will beep 3 times and the display will read...
Press [#] to exit the code programming function.
(*) to Edit <>
User Code 40P
Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
To erase, add or change a user code, press [ ] to enter the function list. Use the arrow (< >) keys to
scroll to the following message...
Press [ ]. Display will read...
Press (*) for <>
Access Codes
Enter the Master Code. Display will read...
Enter Master
Access Code
Use the scroll keys (< >) to find the access code – indicated by "02P" to "32P" –
[*] to Edit <>
User Code 01P
you wish to add, change or delete. Press the [ ] key to select the code you wish to
change. The display will read...
To add or change a code, enter the new code. Access codes must be four digits
Enter New Code
unless otherwise indicated by your installer. Enter digits 0 through 9 only. To delete
1234 <>
an access code, enter [ ]. Once the 4-digit code or [ ] has been entered, the
keypad sounder will beep 3 times and the display will read...
The "P" means the code has been programmed. If there is no "P" then that code is
[*] to Edit <>
deleted. Press [#] to exit the code programming function. The Master code cannot be
User Code 01P
erased.
Remember to record your new code(s) on the "System Information" page in this booklet.
Access Code Attributes
Additional programmable attributes, such as zone bypassing capability, can be activated or deactivated
for each access code. For more information regarding access code attributes, please contact your
installer.
7