Log Grate Installation - Dimplex DLGM29 Owner's Manual

Log grate Installation

1. Fill and install the Refill
Container.
CAUTION:
recommended that Distilled water
or softened water be used in
the unit to prevent scaling of the
components.
!
NOTE: During initial
installation, the Refill Container
should be refilled after the
Reservoir has filled to ensure the
maximum operating time.
2. Make sure the on/off switch
is switched to off (refer to
operating Instruction section).
Figure 2
14
It is strongly
3. assemble power adapter.
(Figure 2) Plug the power
adapter into the front of the
unit, then plug the unit into a
15 amp/ 120 volt outlet.
WARNINg: only use Dimplex
approved 24V DC power supply,
min. 2.7a.
The addition of a mesh spark
screen in front of the Log Grate
and Fireplace tools can be used
to complete the look of your
hearth. (not Included)
!
NOTE: If you need to move
the unit ensure that all of the
components that contain water
have been emptied before
relocating. see Maintenance
Instructions for disassembly.
www.dimplex.com