Heater Installation - Dimplex CDFI-TMHEAT Owner's Manual

Heater Installation

WARNING: ANY
INSTALLATION AND
SERVICE WORK SHOULD BE
PERFORMED BY QUALIFIED
AND AUTHORIZED PERSONNEL.
ALL INSTALLATIONS MUST
COMPLY WITH ALL LOCAL
CODES AND BY-LAWS,
INSPECTED AND APPROVED
FOR OPERATION BY LOCAL
GOVERNING AUTHORITY PRIOR
TO USE.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
!
NOTE: A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A dedicated
circuit will be required if, after
installation, the circuit breaker
trips or fuse blows on a regular
basis when the heater is
operating. Additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
6
Hardwire Installation
The heater is supplied in an
assembled state and is designed
to be permanently installed. The
unit comes ready for hardwire
installation.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
!
NOTE: Please read all
instructions before installing.
1. For rough in framing, the
opening should follow the
recommended dimensions
located in Figure 2.
!
NOTE: Dimensions provided
are minimum clearances and will
vary depending on type of support
framing and finishing options.
!
NOTE: Framing should be
constructed to support 10 lbs
(4.5 kg).
WARNING: To reduce the
risk of fire, do not store or use
gasoline or other flammable
vapors or liquids in the vicinity of
the heater.
www.dimplex.com